7600-SIP-400 Specification
|
| Compatibility |
Cisco Route Switch Processor 720 3C/3CXL, Cisco Supervisor Engine 720-3B/3BXL, and Cisco Supervisor Engine 32 (Sup-32) systems |
| Minimum softwareCompatibility |
Cisco IOS® Software Release 12.2(18)SXE, or later releases for Supervisor Engine 720-3B/3BXL and Supervisor Engine 32 systems in native mode Cisco IOS Software; also, 12.2(33)SRB or later releases for RSP720-GE-3CXL and RSP720-GE-3C systems |
| Protocols |
● TCP
● User Datagram Protocol (UDP)
● IPv4 Unicast and Multicast
● IPv6 Unicast and Multicast
● Multiprotocol Label Switching (MPLS)
● SAToP and CESoPSN |
| Encapsulation |
● Frame Relay
● Point-to-Point Protocol (PPP)
● High-Level Data Link Control (HDLC)
● ATM permanent virtual circuit-constant bit rate (PVC-CBR), variable bit rate real-time (VBR-rt), VBR non-real-time (VBR-nrt), and unspecified bit rate (UBR)
● ATM switched virtual circuit (SVC)-CBR, VBR-rt, VBR-nrt, UBR, UBR+
● TDM over MPLS, ATM over MPLS, and ATM over GRE
● L2TPv3 |
| Cards, ports, and slots |
Four SPA bays per Cisco 7600 SIP-400 |
| Features |
QoS, ACLs, and Low-Speed Aggregation Features
QoS
● Modular QoS CLI (MQC)
● Classification based on:
◦ IP Precedence (IPv6 and IPv4)
◦ Diffserv code point (DSCP) (IPv6 and IPv4)
◦ MPLS experimental values (MPLS EXP)
◦ Extended ACL
◦ ATM CLP
◦ Frame Relay DE
◦ Class of Service (CoS)
◦ VLAN
Congestion Avoidance
● Weighted Random Early Detection (WRED) based on IP Precedence, DSCP, MPLS EXP, ECN (mark IP TOS field for POS traffic)
Queuing
● Congestion management
◦ Per-virtual circuit queuing
◦ Ingress and egress Low-Latency Queuing (LLQ)
◦ Egress Class-Based Weighted Fair Queuing (CBWFQ)
Traffic Classification, Shaping, and Bandwidth Policing
● Marking
● Policing
● Distributed traffic shaping (DTS)
● Hierarchical service policies
Security
● Standard and extended ACLs
Layer 2 and Layer 3 VPNs
● Ethernet over MPLS (EoMPLS)
● ATM over MPLS (ATM over MPLS)
◦ ATM Adaptation Layer 5 (AAL5) virtual circuit mode, single and packed cell relay virtual circuit mode
● Frame Relay over MPLS (FRoMPLS)
● Layer 3 MPLS/VPN over GRE
● ATM over GRE, Ethernet over GRE
● TDM over MPLS
High availability
● IPv4 Nonstop Forwarding (NSF)
● IPv4 Stateful Switchover (SSO)
● Automatic Protection Switching (APS) with ATM, POS SPAs
● OIR for both SIP and SPA
Multilink support
● Frame Relay Multilink^1 (1) Added in >15.2(04)S |
| Memory |
1 GB default Double Data Rate (DDR) synchronous dynamic RAM (SDRAM) per Cisco 7600 SIP-400 |
| Supported SPAs |
Following SPAs are supported on SIP-400 release wise
7600-SIP-400 - POS SPAs Support |
| SPA ID |
Project/Family |
Height |
Min Release |
| SPA-2XOC3-POS |
Sphinx |
Half |
12.2(18)SXE |
| SPA-4XOC3-POS |
Sphinx |
Half |
12.2(18)SXE |
| SPA-1XOC12-POS |
Sphinx |
Half |
12.2(18)SXE |
| SPA-1XOC48-POS |
Iguana |
Half |
12.2(33)SRA |
| SPA-4XOC3-POS-V2 |
Gladiator |
Half |
15.2(04)S |
| SPA-8XOC3-POS |
Gladiator |
Half |
15.2(04)S |
| SPA-2XOC12-POS |
Gladiator |
Half |
15.2(04)S |
| SPA-4XOC12-POS |
Gladiator |
Half |
15.2(04)S |
| 7600-SIP-400 - ATM SPAs Support |
| SPA ID |
Project/Family |
Height |
Min Release |
| SPA-2XOC3-ATM |
Warlord |
Full |
12.2(18)SXE |
| SPA-4XOC3-ATM |
Warlord |
Full |
12.2(18)SXE |
| SPA-1XOC12-ATM |
Warlord |
Full |
12.2(18)SXE |
| SPA-1XOC48-ATM |
Ronin |
Full |
12.2(33)SRA |
| SPA-3XOC3-ATM-V2 |
Barbarian |
Half |
15.0(01) |
| SPA-1XOC3-ATM-V2 |
Barbarian |
Half |
15.0(01) |
| SPA-1XOC12-ATM-V2 |
Barbarian |
Half |
15.0(01) |
| 7600-SIP-400 - GE SPAs Support |
| SPA ID |
Project/Family |
Height |
Min Release |
| SPA-2X1GE |
Wanda |
Half |
12.2(18)SXF |
| SPA-2X1GE-V2 |
Wanda |
Half |
12.2(18)SRB |
| SPA-5X1GE-V2 |
Cricket |
Half |
12.2(33)SRB |
| SPA-1X10GE-V2 |
Scorpion |
Half |
12.2(33)SRB |
| SPA-2X1GE-SYNCE |
SyncE |
Half |
15.0(01) |
| SPA-4X1FE-TX-V2 |
FastEthernet |
Half |
12.2(33)SRD |
| SPA-8X1FE-TX-V2 |
FastEthernet |
Half |
12.2(33)SRD |
| 7600-SIP-400 - CEoP SPAs Support |
| SPA ID |
Project/Family |
Height |
Min Release |
| SPA-24XT1E1-CE |
Velvet Hammer |
Half |
12.2(33)SRB |
| SPA-1XOC3-CE |
Black Russian |
Half |
12.2(33)SRB |
| SPA-2XT3E3-CE |
White Russian |
Half |
12.2(33)SRC(ATM only) |
| 7600-SIP-400 - Serial/Channelized SPAs |
| SPA ID |
Project/Family |
Height |
Min Release |
| SPA-2XT3E3 |
Javelin |
Half |
12.2(33)SRC |
| SPA-4XT3E3 |
Javelin |
Half |
12.2(33)SRC |
| SPA-8XCHTE1 |
Maverick |
Half |
12.2(33)SRC |
| SPA-CHOC3-STM1 |
Prowler |
Half |
12.2(33)SRC |
| SPA-2XCT3 |
Patriot |
Half |
12.2(33)SRC |
| SPA-4XCT3 |
Patriot |
Half |
12.2(33)SRC |
| SPA-4XT-SERIAL |
DocOct |
Half |
15.2(03)S |
| SPA-CHOC12-STM4 |
Chopper |
Half |
12.2(33)SRD |
| SPA-1XCHOC48/DS3 |
Trex |
Full |
15.2(01)S |
| SPA-2XT3/E3-V2 |
Javelin-V2 |
Half |
15.3(3)S |
| SPA-4XT3/E3-V2 |
Javelin-V2 |
Half |
15.3(3)S |
| SPA-8XCHT1/E1-V2 |
Maverick-V2 |
Half |
15.3(3)S |
| SPA-1XCHSTM1/OC3-V2 |
Prowler-V2 |
Half |
15.3(3)S |
| SPA-2XCT3/DS0-V2 |
Patriot-V2 |
Half |
15.3(3)S |
| SPA-4XCT3/DS0-V2 |
Patriot-V2 |
Half |
15.3(3)S |
| Environmentalconditions |
● Operating temperature: 32 to 104°F (0 to 40°C)
● Storage temperature: -40 to 167°F (-40 to 75°C)
● Relative humidity: 10 to 90 percent, noncondensing
● Operating altitude: -60 to 2000m |
| MIBs |
● Cisco Entity MIB (CISCO-ENTITY-MIB)
● Cisco Entity Asset MIB
● Cisco Entity Field-Replaceable Unit (FRU) Control MIB
● Cisco Entity Alarm MIB
● Interface IF MIB (RFC 2233)
● Frame Relay MIB (RFC 1315)
● Cisco Frame Relay MIB
● ATM MIB (RFC 1695)
● Definitions of Managed Objects for Bridges (RFC 1493)
● Evolution of Interfaces Group of MIB-II (RFC 1573)
● SNMP MIB II (RFC 1213)
● Remote Monitoring (RMON) MIB (RFC 1757)
● Switch Monitoring (SMON) MIB |
| Network management |
Supported with CiscoWorks CiscoView
CiscoWorks Resource Manager Essentials (RME)
Cisco IP Solution Center (ISC) |
| Physical specifications |
● Occupies one slot in a Cisco 7600 Series router
● Supports up to 12 Cisco 7600 SIP-400s in a 13-slot chassis
● Requires Supervisor Engine 720-3B or 720-3BXL
● Dimensions (H x W x D): 1.75 x 15.375 x 16 in.
● Weight: 16 lbs not including the packaging |
| Power |
185W power consumption per Cisco 7600 SIP-400
265W maximum power consumption with 4 SPAs |
| Indicators |
Cisco 7600 SIP-400 status: green (operational); orange (faulty) |
| Regulatory complianceSafety |
CE marking
● UL 60950
● CSA C22.2 No. 60950
● EN60950
● TS001
● IEC 60950
● AS/NZS3260
● UL60950
EMC
● FCC Part 15 Class A
● ICES-003 Class A
● VCCI Class A
● EN55022 Class A
● CISPR22 Class A
● AS/NZS3548 Class A
● EN61000-3-2
● EN61000-3-3
● EN61000-3-1
● EN55024
● EN50082-1
● EN300 386 |
| Standards |
Telecommunications
● TU-T G.610
● ITU-T G.703
● ITU-T G.707
● ITU-T G.783 Sections 9-10
● ITU-T G.784
● ITU-T G.803
● ITU-T G.813
● ITU-T G.825
● ITU-T G.826
● ITU-T G.841
● ITU-T G.957 Table 3
● ITU-T G.958
● ITU-T I.361
● ITU-T I.363
● ITU I.432
● ITU-T Q.2110
● ITU-T Q.2130
● ITU-T Q.2140
● ITU-T Q.2931
● ITU-T O.151
● ITU-T O.171
● ETSI ETS 300 417-1-1
● ACA TS 026 (1997)
● BABT/TC/139 (Draft 1e) |
